Spyderco Forums

I took the whole knife apart cleaned everything a spun the stop spin, and it's still sticking. I think the detent is too strong so Im thinking that I need to bend it back some.

My Yojimbo 2 blade was tight to open so I sprayed some oil and loosened the pivot screw. Now when I close it the lock sticks, it never stuck like that before moving the pivot screw. So did I make the compression lock bar slide further into the knife by loosening the blade and adding oil?

Thanks you guys, i somewhat got it sharp, i did the sharpie trick and saw that it wasnt touching when i ran the knife straight up and down, on 30 degrees, so i tilted the knife so it would be at a sharper angle. Then it started to sharpen, but still i cant get the bottom portion of the blade razor ...

i just got my delica yesterday, so i wanted to test the sharpness of it, got a piece of paper and did a cut test. It didnt cut until the very end near the tip, basically its not sharp, so i started to sharpen it on the sharpmaker. But about half way down the blade it wont sharpen for me. I got the ...

thanks you guys got it fixed, sprayed some wd40 by the pivot and its working fine, and the blade is straight now, thanks to DeathBySnooSnoo

When i first got it everything was fine, but couple days later, the blade was harder to open and it sounded like the blade is rubbing against something, so i loosened the pivot screw and everything was fine, but couple days later same thing happen so i tried to loosen the pivot screw and it was ...