In order not to compromise its structral intergrity, he would like to know the location of the blind pins, therefore avoid them as much as possible.
Can anyone kindly share the picture of the tang of the waterway, thanks.
Waterway construction question.
Waterway construction question.
A friend of mine want to modify the waterway to a shorter edc knife, and part of the plan is to grind the handle shorter.
In order not to compromise its structral intergrity, he would like to know the location of the blind pins, therefore avoid them as much as possible.
Can anyone kindly share the picture of the tang of the waterway, thanks.
In order not to compromise its structral intergrity, he would like to know the location of the blind pins, therefore avoid them as much as possible.
Can anyone kindly share the picture of the tang of the waterway, thanks.
-
Michael Janich
- Member
- Posts: 3292
- Joined: Fri Sep 24, 2004 10:33 am
- Location: Longmont, CO USA
- Contact:
Re: Waterway construction question.
Dear Laurarium:
Welcome to the Spyderco Forum.
Stay safe,
Mike
Welcome to the Spyderco Forum.
Stay safe,
Mike
-
RazorSharp86
- Member
- Posts: 484
- Joined: Fri Sep 12, 2008 8:45 am
Re: Waterway construction question.
Sounds to me like Spyderco should just make a smaller, edc sized Waterway. =)
In Magnacut, this time.
In Magnacut, this time.
Re: Waterway construction question.
This is from blade forums, the pics show the tang.
https://www.bladeforums.com/threads/wip ... d.1744969/
https://www.bladeforums.com/threads/wip ... d.1744969/