Just giving y'all the heads up that CCdefense sold out of their initial run of 100 Clinch Picks and trainers without any marketing about the release and the word being spread on a single limited-membership forum. Another 100 should be arriving today or so to keep the ball rolling on getting these to all folks that have wanted them over the years (and years) where they were rarer than hen's teeth due to limited production capability with the custom maker that was making them at the time.
Hopefully this will also reinforce to the folks in the industry that, yes, there IS a demand for reverse-edge knives and trainers out there, especially at around the $100 price point.
100 Production Clinch Picks + Trainers sold in less than 24 hours...
-
psychophipps
- Member
- Posts: 480
- Joined: Wed Oct 07, 2009 9:19 am
- Location: Texas, in the RGV
-
psychophipps
- Member
- Posts: 480
- Joined: Wed Oct 07, 2009 9:19 am
- Location: Texas, in the RGV
For those wanting a picture...
I have heard reports that the scale to lanyard hole and scale to tang grinds are flawless. :thumbup:
The first 100 sold out but there are plenty more where those came from.
No idea on the manufacturer but they are a source that Spyderco uses. Steel is 4mm 12C27 at 59RC. Both come with a tek-loc sheath. Black smudges are kydex dust from the sheaths.
I have heard reports that the scale to lanyard hole and scale to tang grinds are flawless. :thumbup:
The first 100 sold out but there are plenty more where those came from.
No idea on the manufacturer but they are a source that Spyderco uses. Steel is 4mm 12C27 at 59RC. Both come with a tek-loc sheath. Black smudges are kydex dust from the sheaths.