sal wrote:Nice job.
No problem changing hole sizes to 3/16. Let's see how many also want the change.
sal
sal wrote:We thought that would be a standard size, easy to find. :o
sal
Hey Sal,
first of all thank you for the mule team project & I am behind you all the way no matter what I have completed my collector club agreement for the entire mule series & I sent it back to Karen I am in for the long run whatever steel is used I am in :)
I have some questions about the Mule knife you had handles put on - your mule with the black G-10( I think ), the one you sent to Scott Gere for the sheath fitting, can you please describe in detail that knives handles to us.
When I mean describe I mean can you tell us simply about the process, the parts & all pieces you used on your knife especially the screws?
Like what handle material was used how thick that material was ( the fastener length is determined by handle thickness right? ) which /what fasteners you used to hold those handles on which holes the fasteners went thru & used maybe some close - up photos of that knife especially the handles & when you describe the handle hardware please do it in layman's terms so we can go out & find the same handle hardware ourselves, many of us are unable to do this & the ones that can seem a little baffled by this as well.
I am not a knife maker or a handle maker but I would like to try & I would like to have a set of handles I can reuse on future mules.
Before you start talking about changing the hole sizes etc could you please just share with us what you did to your mule because it seems like if you did it maybe it can be repeated but you have the info?
Can I buy the same kind of screws you used on your knife anywhere can I find them locally or will I have to order them from a knife supplier on the internet is what I am wondering & you can clear that up.
These photos are the knife I am talking about.
[CENTER]
[/CENTER]
Thank you in advance for your time & understanding I appreciate it.
~George
:D
