Which is better?
Thanks.
ATS 55 vs. vg 10......
-
The CoPilot
- Member
- Posts: 1130
- Joined: Mon May 14, 2007 5:22 pm
- Location: Lincoln, Nebraska, USA, Earth
- Contact:
"Both good, just different." :)
I myself prefer VG-10. It's a top-notch all around steel. Good edge retention and stain resistance without being a bear to sharpen.
I myself prefer VG-10. It's a top-notch all around steel. Good edge retention and stain resistance without being a bear to sharpen.
><> The most important blood trail leads to the Cross <><
C09 CoPilots My Specialty
Integrity is Being Good Even if No One is WatchingTM
Looking for: C04 Executive plain edge, C09 CoPilot plain edge with brass liners and a G-2 marked blade
C09 CoPilots My Specialty
Integrity is Being Good Even if No One is WatchingTM
Looking for: C04 Executive plain edge, C09 CoPilot plain edge with brass liners and a G-2 marked blade
-
ChapmanPreferred
- Member
- Posts: 2342
- Joined: Fri Sep 24, 2004 10:33 am
- Location: PA, USA
- Contact:
What are your performance needs? I have found VG10 to be more resistant to corrosion and seems to polish up a bit brighter. ATS-55 in my experience can hold an edge just a bit better, but not a large margion. If there was a Spyderdco model that was available in either, I would pick ATS-55 unless the VG10 version was a ton less expensive.
SFO Alumni/Authorized Spyderco Dealer (Startup)
Work EDC List
FRP: Nisjin Cricket PE, Manbug PE, Dragonfly PE
FLP: SS Cricket SE, byrd Flatbyrd CE
BRP: CF Military S90V
BLP: Forum S110V Native
[SIGPIC][/SIGPIC]
Work EDC List
FRP: Nisjin Cricket PE, Manbug PE, Dragonfly PE
FLP: SS Cricket SE, byrd Flatbyrd CE
BRP: CF Military S90V
BLP: Forum S110V Native
[SIGPIC][/SIGPIC]
-
yablanowitz
- Member
- Posts: 7218
- Joined: Sun Apr 09, 2006 2:16 pm
- Location: Liberal, Kansas
