Mantra 4 hype thread

[BornIn1500]

Delivery was delayed because they arrived without lanyard tubes and needed to be sent back to get them installed. Probably a few months.

Strange because the picture on this site shows that it's not supposed to have one.

[Mushroom]

Delivery was delayed because they arrived without lanyard tubes and needed to be sent back to get them installed. Probably a few months.

Oof. How’d you hear about that?

A very knowledgeable Spyderco employee told us

Delivery was delayed because they arrived without lanyard tubes and needed to be sent back to get them installed. Probably a few months.

Strange because the picture on this site shows that it's not supposed to have one.

Well, it is supposed to have one. The picture on the site isn't always accurate.

[zhyla]

Strange because the picture on this site shows that it's not supposed to have one.

Haha, that’s quite an oopsie when nobody notices a part is missing on the prototype and they go and take all the photos.

Sigh. Lanyard tubes are nothing but trouble.

[zhyla]

Geez guys. 6.5 months since I preordered this.

Mushroom, you have an inside scoop on an ETA?

[Mushroom]

Geez guys. 6.5 months since I preordered this.

Mushroom, you have an inside scoop on an ETA?

I know nothing!

When I said "a few months," that was a total shot in the dark on my part. I was just guessing.

To be completely honest, I don't actually know the true cause for the delay in delivery. I didn't mean to spread rumors. Sorry about that.

[Psj78]

I'm excited for this one, in the (contoured!) white G10. It looks like a nice slim and light carry. The 8Cr… steel is fine for my typical uses.

I agree 200%. For my daily edc needs 8cr is fine. Especially when its done correctly like Spyderco does

[zhyla]

To be completely honest, I don't actually know the true cause for the delay in delivery. I didn't mean to spread rumors. Sorry about that.

That’s incredibly confusing but thanks for clarifying.