What Spyderco is in your pocket today??

[Windward]

[Pacu0420]

Just dyed the scales on my Maxa-Manix. So I had to carry it today. It was a little nerve wracking doing the dye job since it's the riveted model. Had to do it with the blade in. I made sure to oil the blade and pivot before starting. Then placed the knife over a heater vent to dry it. It seems to have worked out. No rust. And I prefer the dark brown over the grey.

[Makunochimaster]

[Paul Ardbeg]

Just dyed the scales on my Maxa-Manix. So I had to carry it today. It was a little nerve wracking doing the dye job since it's the riveted model. Had to do it with the blade in. I made sure to oil the blade and pivot before starting. Then placed the knife over a heater vent to dry it. It seems to have worked out. No rust. And I prefer the dark brown over the grey.

You can remove the blade from riveted models. Just undo the pivot screw and take it all out.

[mikey177]

Manix 2 LW Salt

[ladybug93]

Just dyed the scales on my Maxa-Manix. So I had to carry it today. It was a little nerve wracking doing the dye job since it's the riveted model. Had to do it with the blade in. I made sure to oil the blade and pivot before starting. Then placed the knife over a heater vent to dry it. It seems to have worked out. No rust. And I prefer the dark brown over the grey.

You can remove the blade from riveted models. Just undo the pivot screw and take it all out.

have you done this? it's a good way to break your frcp because of the pivot hardware extending into the handle.

[SaltyCaribbeanDfly]

[Manixguy@1994]

MG2

[jwbnyc]

[PStone]

Advocate

[Paul Ardbeg]

Just dyed the scales on my Maxa-Manix. So I had to carry it today. It was a little nerve wracking doing the dye job since it's the riveted model. Had to do it with the blade in. I made sure to oil the blade and pivot before starting. Then placed the knife over a heater vent to dry it. It seems to have worked out. No rust. And I prefer the dark brown over the grey.

You can remove the blade from riveted models. Just undo the pivot screw and take it all out.

have you done this? it's a good way to break your frcp because of the pivot hardware extending into the handle.

Yep, on my Manix 2 LW s110v.

[PeaceInOurTime]

[jmj3esq]

[Mrj]

Those look awesome. I just got the same ones. Haven’t decided on a blade yet.

[kennethsime]

I don’t really pay too much attention to Salts, but this is a great shot, and that’s a great selection of knives!

[SpyderJunky]

Work in progress...

[TkoK83Spy]

[Skywalker]

[Pacu0420]

One of my favorites. Definitely the most carried

[Windward]

stretch2xl salt in in the salt