What did you use your Spyderco for last?

[Bloke]

holes I cut in the plasterboard ceiling.

[JSumm]

Installed 4 LED downlights, and used the Manix to trim the holes I cut in the plasterboard ceiling.

I used those recessed lights when I renovated my Kitchen. They are awesome! Beats the old style and they are so much easier to install. I used the old style on my basement finish before these were a thing. These would have made that job so much easier.

[Brock O Lee]

I got Bloke'd...

I agree JSumm, they are as easy to install as falling off a log... The colour/warmth selector on the LED driver is a nice touch, and makes it so easy to match the light colour to your existing lights.

[PeaceInOurTime]

Q Ball cut my kids' snack this morning and opened the box containing my new Dodo



... which went straight into the pocket

[Chuck James]

I used my Manix2 to dig glass out of my finger and open a package today!!!

[SSD_777]

[vivi]

[PeaceInOurTime]

Cut a few pieces of cord and used as a watermelon utensil.

[Woodpuppy]

I cut the cheese with the new M4arta

[BornIn1500]

[Manixguy@1994]

I should have taken pictures but had to unwrap to rolled outdoor carpets yesterday for the CEO . Job went nicely with the Dragonfly2 Salt PE to do cutting and not damage the carpet . MG2

[donutsrule]

Used a Perrin Street Bowie to slice up some onions and garlic to go in some Shakshuka for dinner, tonight.

[Makunochimaster]

[RevMike]

Wiring up some WWII Navy DC Motors.

[Manixguy@1994]

[Makunochimaster]

[Bloke]

Wiring up some WWII Navy DC Motors.

[Evil D]

Been doing a lot of yard work lately, I decided to clear out a bunch of small trees and saplings around the back of our property. Of course I used a chainsaw for most of it but there were a lot of ~1 inch or smaller stuff that needed cut. I started out using my MagnaMule, I figured being a fixed blade it's well suited for this kind of work but after watching the (very sharp) edge slip off without making a clean cut over and over I got frustrated and pulled out my Autonomy. The difference was enormous, the Autonomy made the same cuts in a single pull or push that the mule slipped off of. I'm gonna play around with different grit edge finished but I think next time I'll just use my Jumpmaster 2 instead of the mule.

[TkoK83Spy]

Funny you say that David, because just last week I was doing similar work as you and decided to give my PMA11 Mule a go. It worked, but was requiring much more effort than I wanted, and needed to use. Out came the Matriarch and the rest is history!

[RevMike]

Yojimbo cutting out some old insulation.