Magnamax performance discussion

[Jeb]

V,

Regardless, man that's lots of cutting lol... I used mine cutting a 5 gallon bucket of okra. Least I get to eat mine lol.

[vivi]

V,

Regardless, man that's lots of cutting lol... I used mine cutting a 5 gallon bucket of okra. Least I get to eat mine lol.

haha tell me about it. this is the hardest ive worked testing a knife.

not much change from bag #3 to bag #6, which is 80% finished.

[vivi]

more vids...


compared against my pocket knife



part 2



filling up bag 6

[cabfrank]

Getting bored yet?
Thanks for posting these videos.

[vivi]

Getting bored yet?
Thanks for posting these videos.

I've been working my way through the Aliens series while I test. Not so bad

[cabfrank]

I was wondering what your distraction was. It would be very tedious otherwise.

[Jeb]

Killer stuff V... the worse part of cutting all the okra was the darn wasp I PO'd and it was doing its best at getting me lol...

That attack didn't end so well for the wasp, few minutes later I knocked it to the ground and ended that little monster. I am not a fan of those, that leave them alone, they won't bother you has always had me bite by those little monsters lol...

[vivi]

tried to wrap up this edge holding test tonight after having a busy week.

cut for an hour. this pile is three feet high, four feet wide in either direction.



still going strong.

I will measure all the cardboard eventually to get the total in miles / feet.

It's going to take a few more orders worth of cardboard at my restaurant before I can complete the test. I keep running out.

At this point I think it's safe to say magnamax matches or exceeds the edge retention of anything else I've used. K390, Rex45, M4, ZDP189, etc.

This puts it at 9 garbage bags of cardboard strips cut, and it's just now barely starting to get hung up every so often. I expect to get to around 15 bags before the edge is sufficiently dulled to stop this test.

Did not expect this much work, to say the least!