I think that is incorrect.Minibear453 wrote:Chopping does put stress on the stop pin. Yet, he described that it was upon pulling the knife out that the lock failed. When the knife is being pulled out, the stress is on the lock. I do not believe that this pulling action should have caused the knife to fail. Maybe it constitutes abuse, yet that decision is up to Spyderco, and in my opinion, it should not be abuse. I've batoned folders right through logs, and they held up. Some of them were even ones that I made, with tolerances far below that of Spyderco's. Even if the lock was over bent, the fact that it still engages (I'm assuming it still engages from the OP's post), means that it should still hold regardless. A frame or liner lock does not depend upon the bending of the titanium to hold the knife open, otherwise they would have to be too strong to be disengaged with one's hand. When the spine is compressed, it is the friction between the blade tang and the lock that keeps the knife open, not the strength of the spring that holds the titanium in place.
A liner/framelock's lockbar needs the proper amount of spring tension to function.