MT36P – K294 MICROCLEAN Mule Team Dropping Soon!
-
- Member
- Posts: 581
- Joined: Tue Oct 24, 2017 5:30 pm
Re: MT36P – K294 MICROCLEAN Mule Team Dropping Soon!
I ultimately skipped this Mule. Looking forward to hearing what you think of it, Steeltoez.
Make Knife Grinds Thin Again.
-
- Member
- Posts: 486
- Joined: Sat Aug 01, 2020 8:51 am
Re: MT36P – K294 MICROCLEAN Mule Team Dropping Soon!
I cut off the factory edge, and put 1 of my own. The burr cut off very easily from what I saw. The result was only 190 however I usually see a performance increase in more testing. I believe my 10V pm2 and Para 3 both hit 375 when it hit their peak. The magnacut I tested hits 350/360 so I'd like to see this k294 hit higher.
"Nothing is built on stone; all is built on sand, but we must build as if the sand were stone."