Para 3 lightweight washer

[rooster81]

One of my lightweights was off center by a bit and didn't have the smoothest action so I added another washer. With the addition of the washer it's now almost dead center and super smooth.

Has there ever been a reason why only one washer is used on the lw para 3?

[aaronkb]

I’d love to know what washer you used/where you got it, I have a few that I’d love to give the same treatment. It’s one of my favorite EDC knives.

[huyfishin]

I’d love to know what washer you used/where you got it, I have a few that I’d love to give the same treatment. It’s one of my favorite EDC knives.

If he told you he would have to kill you

[rooster81]

I’d love to know what washer you used/where you got it, I have a few that I’d love to give the same treatment. It’s one of my favorite EDC knives.

Here you go my friend: https://www.knivesplus.com/replacement- ... jimbo.html

Comes out to $10 shipped for two.

[foofie]

Did you sand down the frn a bit on the original non-washer side?

[rooster81]

Did you sand down the frn a bit on the original non-washer side?

Nope, the washers are pretty thin to begin with. And it seemed to work fine just dropping it in.

[phaust]

$10 is crazy for a set of washers. They're under a buck at any knife part site.

[rooster81]

$10 is crazy for a set of washers. They're under a buck at any knife part site.

$2.50 each, plus shipping.