Spyderco Forums

How soon? And are you in? I am.

Absolutely Coastal ! Dan

Does the pope poop in the woods?!?!!

Coastal wrote: ↑

Tue May 31, 2022 6:57 pm

And are you in?

Missed the H1 Mule so I'm definitely in if it does go down

Didn't expect one to come in, since the steel is almost the same as H-1, and is already gonna be in production for a while if a H-2 Mule is released. No ?

Ramonade wrote: ↑

Wed Jun 01, 2022 11:14 am

Didn't expect one to come in, since the steel is almost the same as H-1, and is already gonna be in production for a while if a H-2 Mule is released. No ?

Good point. I haven't followed the Mule Teams long enough to know if the release only before production or during, as well.

Now 4 new Mule Teams revealed, so it'll be awhile, if ever.

Maybe one of those missing numbers in the sequence of the ones announced is an H2 Mule. I would be in for one or probably two. My daughter and SIL spend a lot of time fishing and paddling and it would be a great knife for them.

I haven't been following H2 since corrosion resistence ranks below flavor on my list of knife steel attribute priorities, but it seems close enough to H1 to share the machining problems that made H1 hollow grind only. That's the single largest reason there was never an H1 Mule Team.

I'm absolutely interested, if it works out. If not, I'll be happy to try it on a salt series knife or similar.

What's the point of it?
There was already magnacut and lc200 mules, both very corrosion resistant and with stronger edge. The feedback for magnacut is quite extensive, not so much for lc200, but still

From The Man himself:

viewtopic.php?p=1639481#p1639481