Spyderco Forums

OK, I'm usually pretty good at puzzles...... butt you stumped me on this one ><g>



How do you configure the Moran sheath into the crossdraw position.

Chinook, you might have the smaller Tek-Lok, which doesn't work for cross-draw. Sal said that they initially shipped Morans with big Tek-Lok, but changed it to smaller one under than impression that smaller one would also work on all carry positions. When they reazlized that it doesn't, they went back to bigger Tek-Lok.

Thanks Hojo
That sounds reasonable, as the diagonal between the clip holes is just short of mating to the mounting holes on the sheath.

Hi Chinook. If cross draw is preferred, contact the office and they'll trade it out for you with the larger clip.

sal

Thanks Sal
butt I think I'll opt for one of these TekLoks for my early mirror polished Moran and try it out first. I assume the sheaths are available alone now? and that the clip part is interchangeable for both drop point and upswept blade sheaths?