Convert PE to SE

Davidig · #1

I know I saw this discussed before, but I can't find the post. Who can I contact to convert a PE Endura (Emerson Wave) to a SE. If you have any personal experience with this I'd appreate your input. Pictures are always nice too.
Thanks
David

Blerv · #2

Someone in another thread mentioned this guy:

http://www.veffsharpening.com/

Frankly I would just look around for a serrated one and sell the PE one when you find it. You wouldn't lose much cash if any and have the Spyderco teeth. Aftermarket mods are best for situations which are impossible (ie: Serrating a Superhawk or Captain).

Davidig · #3

I looked and looked. I dont know if they made a serrated version with the wave.

Davidig · #4

Thank you, I'll check them out
David

SpydieFan · #5

Blerv wrote:Someone in another thread mentioned this guy:

http://www.veffsharpening.com/

Frankly I would just look around for a serrated one and sell the PE one when you find it. You wouldn't lose much cash if any and have the Spyderco teeth. Aftermarket mods are best for situations which are impossible (ie: Serrating a Superhawk or Captain).

FWIW: Veff charges $10 per single serration... so for a larger blade, fully serrating can add up quick. I think I asked about a fully serrated CRKT Drifter and he figured it would take 7-8 serrations, leaving the last 3/8-1/2" plain edge.