Page 1 of 1
Byrd Crosbill
Posted: Tue Feb 12, 2008 2:24 am
by huugh
Posted: Tue Feb 12, 2008 3:54 am
by 224477
Hey, nice to see some pics of the poor man`s civie :D
Posted: Tue Feb 12, 2008 5:56 am
by Blackhair
I want one of these in G-10 so bad!! :D
Posted: Sun Feb 17, 2008 10:35 am
by liberty911
Very good pictures! Only thing that has been keeping me from picking one up is I want it in SE. After seeing these pics though, I might just have to try one out.
Posted: Sun Feb 17, 2008 4:11 pm
by rocketbomb
Nice pictures. I was quite surprised by the size of a Crossbill when I handled one. It would be nice to have a smaller one so it would be a bit less frightening. Then again, if I got a hawkbill it would be one of the Spyder versions. The Crossbill is a very nice knife, though.
Posted: Mon Feb 18, 2008 1:01 am
by jaislandboy
great photos huugh :cool:
Posted: Mon Feb 18, 2008 8:09 am
by PaloArt
Hmmm... Nice. Next to wishlist. :rolleyes:
Posted: Mon Feb 18, 2008 12:21 pm
by Levi
I never wanted one of these until now. Curse your photographs

Posted: Tue Feb 19, 2008 12:26 pm
by LOOKABIRD
Ditto!
Tom
Posted: Tue Feb 19, 2008 5:21 pm
by Blackhair
Is it just me, or does that knife have a very slight Reverse-S curve to it? :confused:
Posted: Tue Feb 19, 2008 7:47 pm
by LOOKABIRD
it's not just you, that's what drew me to it when I saw the pictures. It might be possible with just selective sharpening on a sharpmaker. I think that blade could be made into a reverse-s blade.
Tom
Posted: Wed Feb 20, 2008 10:20 am
by huugh
Blackhair wrote:Is it just me, or does that knife have a very slight Reverse-S curve to it? :confused:
Yes, but very (
very) minor.
LOOKABIRD wrote:it's not just you, that's what drew me to it when I saw the pictures. It might be possible with just selective sharpening on a sharpmaker. I think that blade could be made into a reverse-s blade.
Tom
Pictured is factory edge. No modifications whatsoever.
thumbs up!
Posted: Sun Mar 09, 2008 2:50 pm
by Agent Starling
Very nice pics of a great knife that often doesn't get the attention it deserves! :spyder:
Agent Starling
Posted: Fri Mar 21, 2008 1:15 am
by gandalfe
I also give a, thumbs up, on this nice knife.I just recieved the combo version, and found it to be of good fit, and finish.Has a nice heft to it, and dosen't look cheap, or flimsy.In my opinion it is a great bargain.Great for this tasks, that you wouldn't want to risk, damaging your expensive Spyderco.
