Spyderco Forums

Greetings all!
I have a question about the Ronin sheath. Does the first generation sheath fit the latest Ronin?
Thanks! :D

Wali wrote:Greetings all!
I have a question about the Ronin sheath. Does the first generation sheath fit the latest Ronin?
Thanks! :D

To my knowledge, the Ronin never changed to a perceptable degree. My jaw would drop, if anyone could produce evidence to the contrary.

although what i've heard is that all fixed Spyders have sheaths, fitted at the factory, to each knife. i know for a fact that the Hossom FB's have their sheaths fitted that way

AS much as I love the Ronin I still have a problem with the factory sheath. It seems like everytime I go to put in back into the sheath after using it the knife tip always gets hung up on the wall of the sheath .

It seems to me it should have either a brass sleeve or a sleeve made with something that would keep it from getting hung up.

But once that knife grew on me I have just loved it and adored it ever since. There just has to be a remedy to this problem. I know I'm not the only one who has experienced this problem.

JD,

The problem with the Ronin hanging up on entry into the sheath has to do with the very fine point. If you are just a little bit offaxis and the point contactcs the side, it digs in immediately. After the first time this happens, subsequent entries hang easier because of the divot from the first. Sleeving a sheath would be impractical and add to the cost.

Thanks Guys! The next question is if one of you guys has a square one to trade me for a nifty newer one? Please pm me or email me if this will work for you. I want one that I can back pocket carry one of my Ronins in :)

I might have a old one, I use nifty new one from Mike S. . I'll check tonite

Thanks mr.fb04! I am getting my funds up for one from Mike Sastre. Can I see a pic of your River City sheath please?
Thanks,
Bryan