Superleaf (vertical blade play)

Discuss Spyderco's products and history.
Post Reply
Mike79
Member
Posts: 36
Joined: Mon Dec 05, 2011 6:34 pm

#21

Post by Mike79 »

chuck_roxas45 wrote:A torx set is indespensible to a knife nut. You'll be needing that, if not for this knife, for some other knife.
Long overdue for me I guess. I have to get a sharpmaker next before I buy any more blades.
Top
User avatar
chuck_roxas45
Member
Posts: 8797
Joined: Wed Mar 03, 2010 4:43 pm
Location: Small City, Philippines

#22

Post by chuck_roxas45 »

Mike79 wrote:Long overdue for me I guess. I have to get a sharpmaker next before I buy any more blades.
Yep. The capacity to sharpen and make minor adjustments will be quite invaluable for a knife nut. :D

A new knife is just one knife after all. A sharpening system makes all your knives better.
Top
User avatar
dbcad
Member
Posts: 3111
Joined: Fri Jan 08, 2010 2:59 pm
Location: ga, usa

#23

Post by dbcad »

chuck_roxas45 wrote:Yep. The capacity to sharpen and make minor adjustments will be quite invaluable for a knife nut. :D

A new knife is just one knife after all. A sharpening system makes all your knives better.
+1 :D Said capacity also increases the satisfaction and enjoyment you get from your knives. Also the learning can be half of the fun ;)

Glad the OP's Superleaf turned out well :) It is a terrific model.
Charlie

" Everything should be made as simple as possible, but not one bit simpler."

[CENTER]"Integrity is being good even if no one is watching"[/CENTER]
Top
User avatar
chuck_roxas45
Member
Posts: 8797
Joined: Wed Mar 03, 2010 4:43 pm
Location: Small City, Philippines

#24

Post by chuck_roxas45 »

dbcad wrote:+1 :D Said capacity also increases the satisfaction and enjoyment you get from your knives. Also the learning can be half of the fun ;)

Glad the OP's Superleaf turned out well :) It is a terrific model.
Indeed. :)
Top
Mike79
Member
Posts: 36
Joined: Mon Dec 05, 2011 6:34 pm

#25

Post by Mike79 »

Sharpmaker is en route and should be here tomorrow. Pretty excited. I have an endura 4 that needs some sharpening.
Top
Post Reply

Return to “Spyderco General Discussion”