RevDevil wrote:No worries friend, I will be purchasing 2 of them. I will gladly pick up any slack you leve behind, as will Mr. Newell.
In my opinion, the "mess" as you put it was handled promptly and professionally by Mr. Glesser, I doubt it could have been any better. Mistakes happen, everyone makes them, you?
I meant the pricing issue of $59.95 vs. $84.95 as I quoted in my response. Did not say anything about the recall, Sir.
I apologyze for jumping ahead before the issue was re-affirmed by dapagco.
angusW wrote:I never thought of making dimples on the back of the scales. I usually just sand them a bit. Thanks for the info. So, was it difficult to get the scales off? :D
I should've taken pictures of the many little pieces that the scales turned into. If I'm brave enough to re-scale my M4 Mule, I'll take pictures of the pile of pieces.
JLS wrote:
Something about bearing grease and kitchen use gives me the willies...But you're still breathing, right? :D
Ha ha! [cough... cough...]
Yes, I'm still here. :p Actually, the grease has never oozed out after tightening the crews and wiping down around the edge of the scales. You can smell that it's still in there though. :D
"All your :spyder: are belong to us." ** WTC # 1032 1533 **
I got mine ordered. I was surprised they still have the USN Catcherman in stock, so I ordered another one of those too, and threw in a couple of Spyderco flash drives.
Which Knife, A or B? get Both! (and C, D and E) :)
