MT-42? MT-43? MT-44? MT-45?
MT-42? MT-43? MT-44? MT-45?
Looks like we’re jumping from MT-41 (VG XEOS) to MT-46 (Magnamax). Anybody know what the intervening mules will be? Is one of them 19C27? Vandyman wonders if Damasteel is one of them?
Steel novice who self-identifies as a steel expert. Proud M.N.O.S.D. member 0003. Spydie Steels: 4V, 15V, 20CV, AEB-L, AUS6, Cru-Wear, HAP40, K294, K390, M4, Magnacut, S110V, S30V, S35VN, S45VN, SPY27, SRS13, T15, VG10, XHP, ZWear, ZDP189
Re: MT-42? MT-43? MT-44? MT-45?
Re: The DAMAUKPK Project: Damasteel UK Penknife UKPK
#397 Post Wed Jun 25, 2025 2:11 pm
Hi Vandyman,
Funny you would say that. I told the staff, that when the pieces comes in, we should make a Mule Team as the test piece.
sal
- Don’t know how to do the quotes from one thread to another so I copied and pasted it. I found this response from @sal in regards to me suggesting they should do a mule for us to test. Really, really hoping this is happening. Maybe I need to figure out how to get on the trouble maker list request wise.
#397 Post Wed Jun 25, 2025 2:11 pm
Hi Vandyman,
Funny you would say that. I told the staff, that when the pieces comes in, we should make a Mule Team as the test piece.
sal
- Don’t know how to do the quotes from one thread to another so I copied and pasted it. I found this response from @sal in regards to me suggesting they should do a mule for us to test. Really, really hoping this is happening. Maybe I need to figure out how to get on the trouble maker list request wise.
Greg
MNOSD member #0054
* EDC - PM2 S45VN, Canis S30V, Salt 2 SE LC200N
EDC fixed blade - modified mule SPY27 2
MNOSD member #0054
* EDC - PM2 S45VN, Canis S30V, Salt 2 SE LC200N
EDC fixed blade - modified mule SPY27 2
-
standy99
- Member
- Posts: 2382
- Joined: Sat Jul 22, 2017 11:07 am
- Location: Between Broome and Cairns somewhere
Re: MT-42? MT-43? MT-44? MT-45?
19C27 Could be one of the above.
Mules are numbered from when they are slotted into the system. Meaning some get made quicker than lower numbers because, where they are made might be less of a line up ie; Japan or say Italy etc (As Sal has mentioned before)
We have had a few numbers ahead made before lower numbers several times since the refresh. Magnacut was made way before the two Rex steels which are numbered lower.
It’s good to know there is another 3 in the pipeline besides 19C27
Mules are numbered from when they are slotted into the system. Meaning some get made quicker than lower numbers because, where they are made might be less of a line up ie; Japan or say Italy etc (As Sal has mentioned before)
We have had a few numbers ahead made before lower numbers several times since the refresh. Magnacut was made way before the two Rex steels which are numbered lower.
It’s good to know there is another 3 in the pipeline besides 19C27
Im a vegetarian as technically cows are made of grass and water.