How about...

[Sumdumguy]

...a Lum Tanto with a Ti frame lock?

Obviously, LC200N would be my first choice for the steel. But, I wouldn't be upset if I had to settle for M4 or VG-10. :D

Would anyone else be into something like this or am I just a wacko?

[samdasnake]

That would be such an amazing knife! I've been lusting after a Lum tanto but I can't bring myself to pay the aftermarket prices. That would be a truly beautiful knife with a Ti framelock! Yes, please!!!!

[Sumdumguy]

Well, now I know there's atleast one other nutjob!

[kerrcobra]

I would be very happy for a Ti framelock Lum Tanto in M4 or K390. Not enthused about VG10 or LC200N though.

[benben]

I would be very happy for a Ti framelock Lum Tanto in M4 or K390. Not enthused about VG10 or LC200N though.

Yep, this is where I'm at.....M4

[Sumdumguy]

M4 is as non-stainless as I would want to go.

[ugaarguy]

Yes in LC200N or M390/20CV/204P, or even VG-10. I have no interest in tool steel folders.

[Sumdumguy]

Yes in LC200N or M390/20CV/204P, or even VG-10. I have no interest in tool steel folders.

It's hard to keep them up in my miserable environment.

I have had good luck with M4, though.

Anything crazy would have to be cladded and then everyone would nitpick the lamination lines. Haha!

[Danke]

HAP40/SUS410 is OK.

[Sumdumguy]

HAP40/SUS410 is OK.

If it's laminated, yes.

The blade on my Rex45 PM2 matched the scales after 6 hours in my pocket, while working.

[kerrcobra]

HAP40/SUS410 is OK.

I would pay the exorbitant secondary market prices for one of these, if I could find one.

[Sumdumguy]

HAP40/SUS410 is OK.

I would pay the exorbitant secondary market prices for one of these, if I could find one.

It sure is nice to see a user.