That's the GB1
The issue is that the original hollow grind follows the curvature of the original edge. If you shorten the blade and regrind the edge so that the tip profile is the same, the tip ends up right in the middle of the hollow grind. That causes the edge to grow and grow all the way to the tip, which ends up looking a bit odd. The “right” way to do this would be to redo the hollow grind as well so that it matches the new curvature to the tip, but as zhyla said, most wouldn’t have the equipment to do so.jpm2 wrote: ↑Mon May 25, 2020 4:16 pmI'm not sure that tip placement isn't much different from the original, which would make it the same thickness.Ez556 wrote: ↑Mon May 25, 2020 3:44 pm
I don't have a GB2, anyone post an image for comparison?