UHC - Ultra High Carbon Steel Sprint run ???

A place to list and reference all Spyderco counterfeits, clones, and replicas that are found. Anything that isn't a legitimate Spyderco fits in this area.
Stuman
Member
Posts: 114
Joined: Fri May 26, 2017 2:49 pm
Location: England, United Kingdom.

UHC - Ultra High Carbon Steel Sprint run ???

Postby Stuman » Fri Jan 26, 2018 3:02 pm

HI Guys,

Just seen some beutaful Sandvik Ultra High Carbon Steel, finnish made - knives and it got me thinking, wouldn’t it be great if Spyderco done a sprint run with this steel. I don’t belive in my humble short few years of collecting Spyderco’s I’ve seen any UHC steel knives. I was quite blown away when I saw one of the makers start carving on a piece of steel with no edge deformation or chipping and it still cut paper like it didn’t even know it was chewing on steel a few seconds ago and it was only after doing a little more research that I saw it was easily capable of attaining a Rockwell Of 64 to 66 HRC no less.

What do you guys think ? has Spyderco done a UHC knife before ? if not should they ? Because I’m unaware that they have, so I’m asking if any of you guys know of a model in UHC steel ?
Liberty and the pursuit of happiness is everyone’s god given right :)

Stuman
Member
Posts: 114
Joined: Fri May 26, 2017 2:49 pm
Location: England, United Kingdom.

Re: UHC - Ultra High Carbon Steel Sprint run ???

Postby Stuman » Fri Jan 26, 2018 3:10 pm

Sorry guys I posted this in the wrong forum lol, my bad
Liberty and the pursuit of happiness is everyone’s god given right :)


Return to “Spyderco Counterfeits, Clones, Replicas, etc.”

Who is online

Users browsing this forum: No registered users and 2 guests