Spyderco Forums

Nice work! There’s a lot to like about that design.

Modded a regular Endura. Blade is same length as Endela. I think the Endela would be a fine candidate for a wharnie blade. Not quite this shape though, but it’s what I had to work with.

Nice job Jazz! I'm a big Wharnie fan.

Looks great Boomer!

Spyderco Delica/Mini Street Fighter 3... black peel ply G10 w/royal blue G10 liners...

Been wanting to do this mod for a while now. Finally got around to it this Previously I had rounded the edges of the scales a little, acid stonewashed the clip and made a “mini choil” if you will, as I tend to use it as a utility knife with some fine cutting tasks where I like to pinch the blade with my index and thumb near the tip and have my middle finger up real close to that cutting edge.

Jazz wrote: ↑

Thu Apr 23, 2020 7:00 pm

Modded a regular Endura. Blade is same length as Endela. I think the Endela would be a fine candidate for a wharnie blade. Not quite this shape though, but it’s what I had to work with.

Jazz how did you do that mod?

SpyderCuse wrote: ↑

Fri May 08, 2020 1:56 pm

Jazz how did you do that mod?

I used a Dremel tool with a reinforced cut off wheel, diamond bits, a sanding bit, and a diamond disk for the top. Dipped in water to not ruin the heat treat. For the edge, I cut some with the reinforced wheel, diamond bits, and diamond disk. Various sandpapers and a strop for polishing the spine. Sharpened and made sure the edge was straight, and there you have it.

spyderg wrote: ↑

Thu May 07, 2020 3:03 pm

Been wanting to do this mod for a while now...

Nice job.

Jazz wrote: ↑

Fri May 08, 2020 4:58 pm

SpyderCuse wrote: ↑

Fri May 08, 2020 1:56 pm

Jazz how did you do that mod?

I used a Dremel tool with a reinforced cut off wheel, diamond bits, a sanding bit, and a diamond disk for the top. Dipped in water to not ruin the heat treat. For the edge, I cut some with the reinforced wheel, diamond bits, and diamond disk. Various sandpapers and a strop for polishing the spine. Sharpened and made sure the edge was straight, and there you have it.

Awesome thanks!

Just got done putting some micarta on the Jazzlica :D

Justin that’s awesome!

I agree!

Thanks guys! Hopefully it'll be enough to tie me over until the K390 wharnie is revealed

Endura straight spine mod by Razor Edge Knives. First pic is kind of a before and after type deal.

I half switched scales on my Rex45 and S35VN Native 5’s.
Now they have a Halloween/ Philadelphia Flyers look.

Very very crude and first mod. Testing my more budget friendlies first. Was straightening the spine on the tenacious but ran out of time. Also added a finger choil. The indent on the G10 is just a test for texturing. More to come. After work tomorrow.