Yes, worried me too. There's a youtube of a guy who burned through the top strap(?is that the right word for where frame meets barrel above cylinder gap?) early after introduction of the line. That part of the gun is aluminum in .38s and stainless in .357, however, not polymer.The Mastiff wrote:
I have no experience with polymer revolvers. I think I'd avoid them until I do know more and could make a better decision with them.
We'll see what we see.
Already got plenty of that. 4 joints rebuilt so far, need about 6 more surgeries. The last one was sort of troubling and didn't go well so I'm putting the next off for a while. My hands though arthritic and with nerve damage are still strong, gorilla grips. They do sometimes open up by themselves and drop stuff though. Recoil isn't a problem any more than, say, walking.Arthritis?
Users browsing this forum: No registered users and 12 guests