Discuss Spyderco's products and history.
tique
Member
Posts: 283 Joined: Fri Sep 24, 2004 10:33 am
Location: East TN
#1
Post
by tique » Tue Jul 22, 2003 12:00 am
I just saw one of these bad boys today and have a question as to what the little disk thingy attached to the inside of the lock bar was???
It's a very nice knife by the way<img src="smile.gif" width=15 height=15 align=middle border=0>
Carlos
Member
Posts: 1734 Joined: Fri Sep 24, 2004 10:33 am
Location: Phoenix USA
#2
Post
by Carlos » Tue Jul 22, 2003 10:17 pm
Where'd you see it? The brown truck hasn't delivered mine yet.
tique
Member
Posts: 283 Joined: Fri Sep 24, 2004 10:33 am
Location: East TN
#3
Post
by tique » Tue Jul 22, 2003 11:16 pm
saw it in a local knife shop today, along with a dodo... both have been on backorder for a really long time.
Ted
Member
Posts: 3762 Joined: Fri Sep 24, 2004 10:33 am
#4
Post
by Ted » Wed Jul 23, 2003 1:41 am
Tique, don't know the answer to your question, but were you able to spot what kind of washers are used? (bronze or teflon/nylon?)
Cheers,
Ted
Carlos
Member
Posts: 1734 Joined: Fri Sep 24, 2004 10:33 am
Location: Phoenix USA
#5
Post
by Carlos » Wed Jul 23, 2003 4:24 pm
How were they priced?
tique
Member
Posts: 283 Joined: Fri Sep 24, 2004 10:33 am
Location: East TN
#6
Post
by tique » Wed Jul 23, 2003 9:12 pm
Looked at the ATR a bit closer, the tolerances between the blade and handle are so tight I couldn't tell what kind of washers were used, but there is definately something in there bigger than the pivot.
Prices there are MSRP on the boxes... you can usually get a decent deal though if you chat a bit.
tique
Member
Posts: 283 Joined: Fri Sep 24, 2004 10:33 am
Location: East TN
#7
Post
by tique » Tue Jul 29, 2003 10:04 pm
anybody have any ideas, or perhaps a more official word from the Spydercrew???