Spyderco Forums

UKPK in almost any flavor is a buy for me. Make it a Rex45 and I’ll have 2!

There's a new LC200N Swick coming out later in 2020. It's probably not feasible to do a run in another steel, but some kind of "Forum Knife 2020" etching on the blade should be possible to do. Handle slabs that are exclusive to the forum knife would be a nice touch, but definitely not a requirement.

If ease of production is a key function of getting a forum knife made, this one should be easy to do. And there's some symmetry in having a new 2020 model be the 2020 forum knife.

Cruwear pm2, titanium scales, powder coated blue hardware.... no?

JuPaul wrote: ↑

Fri Jan 10, 2020 7:23 am

Isn't there another british forum that sometimes gets a forum knife? I feel like that's the place for a UKPK forum knife.

britishblades (Where the original UKPK was conceived) closed down, sadly. Edgematters is still around and had a pingo forum knife.

slipit wrote: ↑

Tue Jan 14, 2020 6:00 am

JuPaul wrote: ↑

Fri Jan 10, 2020 7:23 am

Isn't there another british forum that sometimes gets a forum knife? I feel like that's the place for a UKPK forum knife.

britishblades (Where the original UKPK was conceived) closed down, sadly. Edgematters is still around and had a pingo forum knife.

Well that's too bad...it was definitely Britishblades I had in mind.

I like that logo! I only wish Sal would bring back the Spyderwrench as a forum knife...

bearrowland wrote: ↑

Tue Jan 14, 2020 10:35 am

I like that logo! I only wish Sal would bring back the Spyderwrench as a forum knife...

100+

I’d buy two of those right now!

Me too!!