I was at a seminar this weekend and managed to scrap open the knuckles of my training partner pretty good with my Drone. I've noticed before that the "blade" on my drone is cut nice and round but the edges are not rounded over much. By contrast, the "blade" on my CRMIPT is very rounded and smooth, it's very nice work. Is there a way that I can smooth and round the edges on my Drone?
Lunumbra
Smoothing the edges of a Drone?
Clamp the handle in a vise with some cardboard to protect the finish.Then use a strip of cloth backed emory on the edge much like a shoeshine buffs with a cloth.Progressivly finer grits of emory should give you a smooth finish.This method is better than using a grinding wheel as you have more control.
-
- Member
- Posts: 2936
- Joined: Fri Sep 24, 2004 10:33 am
- Location: Kuala Lumpur Malaysia