I used a Dremel with a fine grit sanding barrel to reshape it and then I believe 200 grit sandpaper to blend in the sanding marks with the rest of the tang. I would recommend either taking it apart to do this or tape up the whole knife so just the flipper tab is left showing, otherwise you'll get metal dust inside the pivot.toocool006 wrote: ↑Wed Sep 05, 2018 9:28 pmWould love to hear a bit about your process and toolkit - are you just using sandpaper? A dremel? What kind of grits? I'm a novice to modding but would to bob the flipper tab just a shade, and figure this is about as good a place to start the modding journey as any.