Hello All! Long time no posting I hope everyone is well.
Quick question, well 2.
Assuming the model is the exact same model (all delica 4, PM2s etc no mix match models), what parts need to move over during a blade swap?
As best as I can tell it should be the blade and in most/all the lock bar. Is that it? The other internals etc can stay with the scales?
Specific I want to swap 2 endura 4s, but I'll want to try more later for sure.
2nd, isn't now when the disco list comes up or have I not searched enough yet?
Thanks in advance, if I do a swap you'll know. Happy New Year!
Blade swap question
Re: Blade swap question
In my experience , and I've blade swapped and scale swapped a lot of my Delicas , I've found what gives best results is to swap Blade and Lockbar and the screw fittings for both the lock bar and Blade pivot .
The other screws and liners etc don't seem to have much impact on success .
Good luck .
Ken
The other screws and liners etc don't seem to have much impact on success .
Good luck .
Ken
-
- Member
- Posts: 6909
- Joined: Sun Apr 09, 2006 2:16 pm
- Location: Liberal, Kansas
Re: Blade swap question
The discontinued list actually came out a month or more ago. A search should find it easily.
Re: Blade swap question
I would keep blades with their matching lock bar/liner/etc.
All SE all the time since 2017
~David
~David
- Half Sack
- Member
- Posts: 260
- Joined: Sat Apr 30, 2011 12:55 am
- Location: Alberta, undisclosed location of the Weapon Plus Program
Re: Blade swap question
I didn't think of the screws for the lock and pivot.
I'll search for the disco list, I did try a quick search but it was while posting about the swaps.
I'm thinking about picking up 2 Enduras and doing a 'three-way' two won't be as cool.
Hate to wreck the site with silly questions.
Happy New Year's from 8pm Alberta
I'll search for the disco list, I did try a quick search but it was while posting about the swaps.
I'm thinking about picking up 2 Enduras and doing a 'three-way' two won't be as cool.
Hate to wreck the site with silly questions.
Happy New Year's from 8pm Alberta
- The Deacon
- Member
- Posts: 25717
- Joined: Fri Sep 24, 2004 10:33 am
- Location: Upstate SC, USA
- Contact:
Re: Blade swap question
Safest way is to do a scales swap (scales and backspacer in the case of FRN models unless your looking for a two-tone effect) rather than a blade swap.
Paul
My Personal Website ---- Beginners Guide to Spyderco Collecting ---- Spydiewiki
Deplorable :p
WTC # 1458 - 1504 - 1508 - Never Forget, Never Forgive!
My Personal Website ---- Beginners Guide to Spyderco Collecting ---- Spydiewiki
Deplorable :p
WTC # 1458 - 1504 - 1508 - Never Forget, Never Forgive!
- spyderHS08
- Member
- Posts: 1790
- Joined: Wed Apr 04, 2007 3:50 pm
- Location: KS, USA, Earth