Spyderco Forums

murphjd25 wrote: ↑

Thu Oct 10, 2019 1:30 pm

Enactive wrote: ↑

Thu Oct 10, 2019 1:02 pm

murphjd25 wrote: ↑

Wed Oct 09, 2019 9:30 pm

Had my Advocate bead blasted. Looks a lot better now and is not slippery in the hand at all.

That looks good. What media was it blasted with?

Glass :)

:cool:

elena86 wrote: ↑

Wed Oct 09, 2019 10:44 am

Thickness behind the edge ?

Calipers not in my possession currently.

Well used EDC. Rhino and Cru-wear Para3 on a pocket shield.


Hair courtesy of Gus the Dog.

Great bright color for pics... :D

JRinFL wrote: ↑

Fri Oct 11, 2019 8:56 am

IMG_0334.png

Well used EDC. Rhino and Cru-wear Para3 on a pocket shield.


Hair courtesy of Gus the Dog.

What's a pocket shield for?

Vivi wrote: ↑

Fri Oct 11, 2019 2:30 pm

What's a pocket shield for?

It allows you to clip a knife, light, mags, etc to the shield and slip the entire thing into your pocket. No clips show outside, no printing either. I got tired of shredded steering wheels, worn pockets, and scratches.
If I haven’t forgotten, they are made by Raven Concealment.

All this micarta talk this week had me grab this guy for a little half day of work...

I am still in the process of learning what works best for me when it comes to sharpen SE H1.
But as of right now I like to finish with the white rods after the browns (on VG10 PE I only use the browns normally).

Freshly sharpened. I like the way it cuts with the smoothed out serrations.



I ground it at 15 degrees on diamonds until I raised a burr on the back, then refined the apex until it could shave. Then a couple strokes per side on the fine rods. Very sharp!

5-by-5 wrote: ↑

Fri Oct 11, 2019 9:02 pm

I'm jealous of that spyderhawk...and that dirty martini!

More and more it's becoming a "mountain knife"... :)

PeaceInOurTime wrote: ↑

Mon Oct 14, 2019 4:33 am

I am glad your Endura is back!
Always love to see it in this thread...