SM-35M50 Micromelt Steel looks amazing!

Discuss Spyderco's products and history.
Cliff Stamp
Member
Posts: 3852
Joined: Sat Dec 31, 2005 2:23 pm
Location: Earth
Contact:

Postby Cliff Stamp » Sat Dec 28, 2013 5:19 pm

WorkingEdge wrote:I assume there is no quick and dirty estimate that says edge finish should be some multiple of carbide size with the dps being some trig function of the carbide size.
Not as of yet. As noted :

http://www.cliffstamp.com/knives/reviews/cardboard.html

This shows the optimal carbide peak for the given geometry noted and it is necessary to go above and below that angle to suit the lower and higher carbide steels. That table will be expanded with such work which can then show at a given edge finish the optimal angle as a function of carbide volume. This data can then be added to by repeating the entire thing with a more coarse and more fine finish to added the edge finish angle. Note that this is of course for a given force/speed of cutting on a given medium, different materials being cut with different methods will also change the optimal points.

User avatar
sal
Member
Posts: 13177
Joined: Fri Sep 24, 2004 12:00 pm
Location: Golden, Colorado USA

Postby sal » Sat Dec 28, 2013 5:55 pm

Hi Cliff,

Sounds like an interesting project. Let me know if there is anything we can do to help? It's challenging to be sure.

sal

WorkingEdge
Member
Posts: 209
Joined: Sun Apr 14, 2013 1:35 am

Postby WorkingEdge » Sat Dec 28, 2013 11:57 pm

Very ambitious indeed. Hope you have a lot of grad students available to you.

Thx for your insight.

User avatar
Strong-Dog
Member
Posts: 703
Joined: Sat Dec 14, 2013 7:49 pm
Contact:

Re: SM-35M50 Micromelt Steel looks amazing!

Postby Strong-Dog » Wed Apr 01, 2015 6:45 pm

April fools mother-truckers


Return to “Spyderco General Discussion”

Who is online

Users browsing this forum: abiggs, benben, Cambertree, Karl_H, RustyIron, sal, skeeg11, SpyderCuse, stoby22, vaisforlovers and 45 guests