VIDEO: Para 2 Sprint Run in CTS-20CP - EDC Cutting Series

Discuss Spyderco's products and history.
Post Reply
User avatar
Ankerson
Member
Posts: 6931
Joined: Sat Jul 24, 2010 1:23 pm
Location: Raleigh, NC

VIDEO: Para 2 Sprint Run in CTS-20CP - EDC Cutting Series

#1

Post by Ankerson »

<iframe width="480" height="390" src="http://www.youtube.com/embed/QBV-f7wpw9s" frameborder="0" allowfullscreen></iframe>
Top
User avatar
Zatx
Member
Posts: 711
Joined: Fri May 04, 2007 5:26 am

#2

Post by Zatx »

Knife porn.. gotta love it.
“Open, close, cut, clean, oil, cut, cut, cut... To a Spyderco, that is living. Letting it die in the box is to lose 75% of what we put into it." -----Sal Glesser
Top
User avatar
Jonj480
Member
Posts: 52
Joined: Wed Feb 16, 2011 11:51 pm
Location: SW Ohio

#3

Post by Jonj480 »

Holy crap Jim. Was there any edge degradation at all? It didn't appear that it lost any of its aggressiveness or sharpness at all during the test.

Love to see Spyderco release a Military in this steel too!

Did you notice any chipping or rolling? It didn't appear by the way the paper sliced that there was any.
Top
User avatar
Ankerson
Member
Posts: 6931
Joined: Sat Jul 24, 2010 1:23 pm
Location: Raleigh, NC

#4

Post by Ankerson »

Jonj480 wrote:Holy crap Jim. Was there any edge degradation at all? It didn't appear that it lost any of its aggressiveness or sharpness at all during the test.

Love to see Spyderco release a Military in this steel too!

Did you notice any chipping or rolling? It didn't appear by the way the paper sliced that there was any.
There really wasn't any loss in sharpness, it's like S90V, it just gets even more aggressive. :eek:

No chipping or rolling at all.
Top
User avatar
kbuzbee
Member
Posts: 4764
Joined: Sun Aug 13, 2006 8:37 am
Location: Mentor, OH

#5

Post by kbuzbee »

Sounded like someone considered you were creating a fire hazard :)

Nice vid!

Ken
玉鋼
Top
Post Reply

Return to “Spyderco General Discussion”