Search found 5 matches
- Sat May 05, 2018 2:59 pm
- Forum: Spyderco General Discussion
- Topic: Steel that takes the keenest (sharpest) edge?
- Replies: 107
- Views: 18423
Re: Steel that takes the keenest (sharpest) edge?
In theory, the ease of sharpness wouldn't matter, as I simply asked for the sharpest edge possible. However, in practice, it does matter because if I don't have the skill or tools to reach that theoretical sharpness, it's pointless. :D So yes, ease of sharpening should factor into the equation. I do...
- Sat May 05, 2018 12:26 pm
- Forum: Spyderco General Discussion
- Topic: Steel that takes the keenest (sharpest) edge?
- Replies: 107
- Views: 18423
Steel that takes the keenest (sharpest) edge?
I like to sharpen, and admit I'm a sucker for the parlor tricks (whittling hair, silently cutting phone book paper, etc.) So, among the steels that Spyderco uses, which ones take the keenest edge? Bonus points if it's available on one of the "classic" EDC models (I'll let everyone decide w...
- Sun Sep 07, 2014 8:14 am
- Forum: Spyderco General Discussion
- Topic: Question about keeping blade angle consistent w/Sharpmaker
- Replies: 10
- Views: 2364
Re: Question about keeping blade angle consistent w/Sharpmak
Thanks for the replies, and thanks for the welcome. Cliff, may I ask what you mean by tilting horizontally? (My limited vocabulary concerning 'planes and axis' creates confusion sometimes.) Do you keep the knife still vertical, or is there a rotation on the horizontal axis and the blade is no longer...
- Sat Sep 06, 2014 10:02 pm
- Forum: Spyderco General Discussion
- Topic: Question about keeping blade angle consistent w/Sharpmaker
- Replies: 10
- Views: 2364
Re: Question about keeping blade angle consistent w/Sharpmak
I like your terminology, so I want to borrow it. As wordy as the orginal post was, I may not have been very clear. The third option I described would be vertical, level but not perpendicular. (Or rather, it starts off perpendicular but is not perpendicular from the belly to the tip. ) If you where s...
- Sat Sep 06, 2014 9:38 pm
- Forum: Spyderco General Discussion
- Topic: Question about keeping blade angle consistent w/Sharpmaker
- Replies: 10
- Views: 2364
Question about keeping blade angle consistent w/Sharpmaker
After sharpening on belts for a while, I pulled out my Sharpmaker. Am I supposed to raise vertically the handle as I bring the blade down the stone when using the flat side? Or am I supposed to keep the spine of the blade more or less parallel to the surface? Or am I supposed to move the handle slig...