Spyderco Forums

I think M398 works well at 15-17 degrees per side. I found in my own use/ testing it didnt have the strength/stability to handle lower angles. So i had to raise the edge angle higher than i personally prefer to decrease the rapid apex deformation i was seeing. Once i found that sweet spot its held ...

Hi Jasonfromvk,

Welcome to our forum.

sal


Thanks, and sorry for any misunderstandings in the past.

I don't believe that you were asking my personal opinion on the chemistry, it's.. I'm not going to say a basic alloy the higher .7 Si is something that I personally have been looking into with ...

Hi Hatuletoh,

Interesting chemistry. Do you know of any companies making a cutting tool(s) with any of the versions?

sal


I was going to post this in the rex121 thread, but my personal opinion is that you guys should stop doing research on ceramics. Mike apparently thinks that I dislike you ...

Anyone else been using the M398 lately? I've swapped it to my primary use knife and I've been more impressed as I use it more. Stays sharp a long time, zero corrosion problems so far, and my favorite thing is it cuts frozen meat without much wear.

It was a bit of a learning curve to figure out ...